A Quick Guide on How to Replace Your Winter Pool Cable
In this tutorial, we’ll walk you through the steps to properly replace your winter cable, ensuring your pool cover is securely fastened for the cold season.
Key Takeaways:
Remove the winch and loosen the old cable before pulling it out from the cover grommets.
Thread the new cable through the cover’s grommets, moving over and under for a secure fit.
Use the winter winch to tighten the new cable and secure your pool cover.
Step-by-Step Process:
Begin by removing the winter winch. Push down on the lock nut, hold in position, and turn the wing nut counterclockwise to loosen the cable.
Pull out the cable from each side of the winch.
Remove your winter cover from the pool.
Slowly pull out the old cable from the cover grommets.
Thread the new cable through the grommets, moving over and under the cover.
Tie the two ends of the new cable together in a knot to hold in place.
Apply the winter cover back onto the pool.
Insert the cable ends into opposite sides of the winch and tighten by turning the wing nut clockwise until the cable is secure.
Resources and Explanations:
Winter Cable: This cable ensures the pool cover stays securely in place during harsh winter conditions.
Winter Winch: The winch tightens the cable around the pool cover, making sure it's snug and protective.
FAQs:
Q1: How often should I replace the winter cable?
A: Replace your winter cable when it shows signs of wear, fraying, or if it’s difficult to tighten.
Q2: Can I reuse the same winch with a new cable?
A: Yes, as long as the winch is functioning properly, you can use it with a new cable.
Q3: Should I fully tighten the cable before placing the cover?
A: No, tie the cable loosely and fully tighten it after placing the cover back on the pool.
That's how you successfully replaced your winter cable and secured your pool cover. If you have any further questions or need assistance, visit your local Great Escape store. We’re always here to help!
Comments